JACK C5T-5-A04/435
Instalment calculator – external content.
Cookie settingsInstalment calculator – external content.
Cookie settings
Industrial high-speed five-thread overlocker with top fabric feed, automatic thread trimming and presser foot lifting.
C5T series overlockers have a top and bottom fabric feed system, so fabric layers do not shift. Depending on the version, overlockers in the series finish edges with three, four, five or six threads; this model is a five-thread version (2 needles) made for denim.
The integrated new-generation servo motor runs very quietly and uses up to 80 % less electricity than old-style clutch motors. The overlocker can be supplied with a standard or a recessed table – in the latter case the sewing platform is level with the tabletop.

Features

Control panel in the housing
New-generation control panel integrated into the machine housing.
Needle bar that keeps oil off fabric
A special needle bar system prevents oil from getting onto the fabric.
New shaft design
The machine runs even more smoothly and quietly.
Stitch samples

Specifications
- Fully automated: programming, thread trimming, presser foot lifting
- Top and bottom fabric feed system
- Integrated new-generation servo motor
- Maximum sewing speed 6000 stitches/min
- Number of threads: 5 (2 needles, 5 mm gauge)
- Needle type DCx27 #19
- Differential feed range 0.8–1.5
- Central lubrication system
From the manufacturer leaflet

Top and bottom differential feed
The top and bottom feed move the fabric together, so the upper and lower layers of long pieces do not shift or distort.

Strong feeding of heavy materials
750 W motor and a new transmission design – the machine sews smoothly over cross seams and ridges. According to the manufacturer, coral velvet is sewn in 4 layers normally and 6 layers over a ridge.

Higher presser foot lift – 7 mm
Thick fabrics such as cotton garments or down jackets are easy to place under the foot.

Voice guide and three working modes
The control panel gives voice reminders and helps solve common faults. One key switches between fully automatic, semi-automatic and computerized mode.
Other C5T series features

Mesh fabric mode
A mode for thin and see-through fabrics, so the sensor does not start the machine by mistake.

Fourth sensor – shorter thread chain
An additional sensor detects the fabric end more precisely, leaving a thread chain of about 5 mm (typically about 15 mm).

Fast acceleration and stopping
The machine reaches 5500 rpm in about 0.1 s and stops in about 0.18 s.
Technical data
| Application (manufacturer table) | jeans exclusive |
|---|---|
| Needles / threads | 2 needles, 5 threads |
| Needle system | DCx27 #19 |
| Needle gauge | 5 mm |
| Overedge width | 6 mm |
| Stitch length | up to 5 mm |
| Differential feed ratio | 0.8–1.5 |
| Presser foot lift | 7 mm |
| Maximum speed | 6000 stitches/min |
| Motor | 750 W, integrated |
| Packed size | 505 × 360 × 565 mm |
| Weight (head net / gross) | 29.2 / 39.8 kg |
Documents
Work table extension module (+25 €)
This fold-out module enlarges the work table. You can choose it when ordering the product.
Any questions?
Call +370 685 85915 or email info@siuvimomanija.lt. We will help you check whether this overlocker is right for your work.
